Kylee & Co
Seat Belt Button Stopper
Seat Belt Button Stopper
Couldn't load pickup availability
Description:
This simple clip-on seatbelt button helps stop your seatbelt from retracting too far, so it stays right where you need it, and is easy to reach, and easy to grab. It’s especially helpful for anyone with limited mobility, chronic pain, or fatigue who finds it difficult to stretch or pull the seatbelt from a fully retracted position.
It also supports those with sensory sensitivities by helping reduce tightness or pinching from an over-retracted belt, which can make wearing your seatbelt that little bit more manageable and comfortable too.
Whether you find seatbelts hard to reach, uncomfortable to pull, or just a bit of a hassle, this simple tool can help. It’s great for anyone with reduced mobility, fatigue, sensory sensitivities, limb differences, or those recovering from injury or surgery.
No tools or special fittings needed.
Great for:
🪢 Preventing seatbelts from retracting out of reach
✋ Reducing strain for people with mobility challenges
💥 Supporting sensory comfort while travelling
👨👩👧👦 Everyday use in cars, vans, or mobility vehicles
🧰 Easy, tool-free install — just clip on and you’re good to go
⚠️ Important Information: This product is designed to help keep your seatbelt within easier reach. It does not, and must not, interfere with the seatbelt’s ability to retract, lock, or protect you at any time.
🔒At all times please ensure that you:
✅ Always make sure the seatbelt fits snugly across your chest and lap.
❌ Do not leave excess slack or place the stopper in a way that compromises function.
🚨Your seatbelt must still be able to restrain you properly in the event of a crash. If unsure, refer to your vehicle’s safety guidelines.
Image Description: A set of small black plastic seatbelt stop buttons, shown beside a car seatbelt strap. The buttons are round with a central pin and are designed to snap around the seatbelt webbing to stop it from retracting too far. One button is pictured already attached to a seatbelt in use, holding the strap in place near the buckle. Additional buttons are displayed in a row to show both front and back sides.
Details:
Material: ABS Plastic
Size: 1.6cm (diameter)
Weight: less than 10 grams
Package Contains: 2x sets Seat Belt Button
How to Use / Install:
- Pull the seatbelt out to the position where you want it to stop retracting. This should usually be just far enough to keep it within easy reach.
- Mark the spot where the stopper will go.
- Carefully make a small hole through the seatbelt fabric at that spot using a pin or pointed tool.
- Push the centre pin of the stopper through the hole.
- Snap the two halves together until they click securely in place.
- Test the belt by letting it retract. It should now stop at the button, keeping it in an easier reach.
Share







